Skip to content
Licensed Unlicensed Requires Authentication Published by De Gruyter April 2, 2015

Determination of Mn valence states in mixed-valent manganates by XANES spectroscopy

  • Alain Manceau EMAIL logo , Matthew A. Marcus and Sylvain Grangeon
From the journal American Mineralogist

Abstract

The valence states of Mn in mixed-valent layer and tunnel structure manganese dioxides (MnO2), usually referred to as phyllomanganates and tectomanganates, can be measured by X-ray absorption near-edge structure (XANES) spectroscopy with a precision and accuracy that are difficult to estimate owing to the paucity of well-characterized standards. A compilation of the Mn K-edge XANES spectra of most naturally occurring manganates, synthetic analogs of known structure and chemical composition, and pure-valence phase species is presented and made available as an open source. We intend this compilation to serve as a basis for the spectroscopic determination of the fractions of the Mn 2+, 3+, and 4+ valences in mixed-valent manganates and phase mixtures. The XANES derivatives of tectomanganates and phyllomanganates with no or little Mn3+ in the MnO2 layer exhibit intensities, shapes, and relative energy positions of the main features characteristics of a particular valence composition. For these compounds, valence fractions can be derived using linear combination fitting analysis. Best quantitative results are obtained when the unknown spectrum is fit to a weighted sum of all reference spectra in the database with the fractions of species constrained to be non-negative (Combo method). The accuracy of the average valence is estimated to 0.04 v.u. in the range of 3+ to 4+, and decreases when the proportion of divalent Mn is higher than 15%. The accuracy of the method is also lower in (layer Mn3+, Mn4+) manganates, because the XANES features are affected non-additively by the amount and distribution of the Jahn-Teller Mn3+ cations. The merit of the Combo method for the determination of manganese valence sums relative to the methods based on calibration curves is discussed.

Received: 2011-6-4
Accepted: 2012-2-5
Published Online: 2015-4-2
Published in Print: 2012-5-1

© 2015 by Walter de Gruyter Berlin/Boston

Downloaded on 29.3.2024 from https://www.degruyter.com/document/doi/10.2138/am.2012.3903/html
Scroll to top button