Simultaneous determination of silicon and phosphorus in cast iron by 14 MeV neutron activation analysis

Abstract

A fast (10 min), non-destructive simultaneous determination of silicon and phosphorus in cast iron and steel by 14 MeV neutron activation was developed. The 1.78 MeV²⁸Al activity (T=2.24 min) induced by the reaction²⁸Si(n, p)²⁸Al is counted on a NaI(Tl) detector. Two measurements are made to correct for the 1.81 MeV⁵⁶Mn activity (T=2.58 hr) from the iron matrix. However,²⁸Al is also produced via³¹P(n, α)²⁸Al. By (n, 2n) reaction, phosphorus yields also³⁰P (T=2.6 min), the 0.511 MeV annihilation radiation of which is counted by two opposite NaI(Tl) detectors in coincidence. Again, two successive coincidence measurements are carried out in order to take into account the⁵³Fe activity (β⁺; T=8.9 min) from⁵⁴Fe(n, 2n)⁵³Fe. The²⁸Al measurement is appropriately corrected via the computed phosphorus content. An oxygen flux monitor was used to normalize to the same flux. Nuclear interferences have been examined. Special attention has been paid to the presence of copper. The standard deviation for phosphorus being as high as ca. 0.09% P for a single determination, this technique can only be practical as an independent phosphorus analysis for high phosphorus cast irons. The precision on the²⁸Al measurement is 5% relative for 0.2% Si and 2.5% above 1% Si.