Hostname: page-component-7c8c6479df-ph5wq Total loading time: 0 Render date: 2024-03-29T04:42:47.278Z Has data issue: false hasContentIssue false

Errors in the determination of ablation using stakes: comments on Dr. Vallon’s letter

Published online by Cambridge University Press:  30 January 2017

Michel Vallon*
Affiliation:
Laboratoire de Géophysique et Glaciologie, 2, rue Très-Cloîtres, Grenoble, France
Rights & Permissions [Opens in a new window]

Abstract

Type
Correspondence
Copyright
Copyright © International Glaciological Society 1968

Sir,

It seems that most mass balance determinations with a net of ablation stakes have been made without taking into account the fact that, when the lines of flow are not parallel, the emergence −e (variation of the length l of the stake immersed in ice) of the stakes is not equal to the ablation −b. This is perhaps one of the causes of the curious undulations shown by curves of ablation versus altitude.

Ice being incompressible ∂w/∂z = −(∂u/∂x+∂v/∂y) (evident notation; Oz vertical, positive downwards).

For a stationary glacier w on the surface is −b; at the lower end of a stake of length l, w is −b+lw/∂z.

When short stakes are used it is generally their feet which are linked to the ice (in temperate glaciers, where holes are full of water and do not close, an anchorage at the foot is necessary when wooden stakes are used). Thus the emergence of a stake will be lower than the ablation in compressive flow (∂u/∂x < 0) and higher in extensive flow.

This effect is generally a small one, but it is not negligible—for instance if l = 2m, ∂u/∂x = −0.1 year−1, and ∂v/∂y = 0, it implies that −b = −e+0.2 m). Its correction is absolutely necessary near ice falls, as ∂u/∂x rises to 0.3 to 1 year–1. To calculate the correction it is necessary to remember that strain-rate is a continuous process and ablation is an intermittent one, and that while it is occurring strain-rate acts on a variable length l.

It is usually convenient to set systematically two stakes (about 10 m apart) along the same line of flow to evaluate ∂u/∂x (it is almost always possible to estimate ∂v/∂y on a small-scale map by observations of divergence or convergence of moraines or active glacier edges).

When articulated stakes (rods with an anchoring system at the foot of each, joined together with little chains) are used, it is necessary to know whether lower rods have or have not pulled or pushed the upper rod.

In regions of extending flow the whole stake is pushed up by the lower rod and knowledge of ∂w/∂z is sufficient, but when the flow is strongly compressive it becomes necessary:

  1. to provide a sufficient length of chain and a very good anchoring system (such as a stainless steel spring blade of sufficient length);

  2. at every survey, to note if the upper rod is well anchored, to push it down, and note its emergence before and after pushing.

In a cold glacier anchorage is very good and it is necessary to estimate carefully the minimum length of all the little chains (ablation often being small, the stakes will stay in the ice a very long time).

I would like to thank Professor Lliboutry for his good advice and criticism.

14 April 1967